Unimet Gear Roller Testing (GRT) systems are used to measure the critical parameters in gears. Today, we present our Manual Gauging with SPC to check DFCE with SPC analysis. The component Loading & Unloading is done manually.rnrnThe Gear Rolling Tests are special measuring procedures where a test gear and a master gear of higher accuracy grade are rolled against each other, obtaining. As a result, parameters represent the future actual working conditions of the test gear. Gear Rolling Tests are functional tests where the quality grade of a gear unit is determined by rolling it against a higher quality (precision) master gear. They also check complete transmissions and match gears in their optimal position.
Parameters measured
Measurement of critical parameters for the Gear component
Measurement of critical parameters for the Counter shaft component
Measurement of critical parameters for the shaft at two levels
Measurement of critical parameters for the shaft at multiple levels
Measurement of critical parameters for the Crankshaft
Measurement of critical parameters for the Balancer Assembly
Measurement of critical parameters for the Balancer Shaft
Measurement of critical parameters for the Balancer Shaft