Unimet Multi-gauging systems are used to measure several dimensions simultaneously with manual intervention and loading. Parts to be gauged are compared with a setting master, which has similar dimensions as that of the actual component to be measured. Some parameters to be measured (but not limited to) could be external/internal diameters, lengths, straightness, squareness, ovality, run-out of faces, etc.
This Fixture is used to measure the following or the connecting rod
Measurement of critical parameters like
Measurement of critical parameters and geometry for the crown wheel component
This Fixture is used to measure the following parameters.
Measurement of critical parameters for the Ring Gear component
Measurement of critical parameters for the compressor housing component
Measurement of critical parameters for the Input Shaft component
Measurement of critical parameters for the Rotor Shaft component
Measurement of critical parameters for the Housing Pinion component
Measurement of critical parameters for the Pinion gear